Digital Design‎ > ‎

Project Guide

Guide for completing the term project required for SKEE2263 Sistem Digit course.


Basically, you must complete 6 tasks, at the end of each you'll achieve a milestone.
Milestones 1 is the same for everybody.
For the actual project, go through Milestones 2-6. 
Choose a project topic from the topics listed here

In simple terms, you will perform top-down design and bottom-up implementation

For the top-down design part, understand the overall circuit design which consists a datapath unit and a control unit. The datapath unit contains many modules. Break the design into smaller and smaller components until you reach a level suitable for schematic capture design entry.

Then, perform the bottom-up implementation task.
  • Milestone 3: implement the combinational components of the data path unit
  • Milestone 4: implement the sequential components of the datapath unit
  • Milestone 5: integrate all parts from milestone 3 and 4 to achieve a working datapath unit
  • Milestone 6: implement control unit. Merge the datapath unit with the control unit. Done.
The master document for the semester project is here.

A tutorial for implementing a serial adder is here. You can use it as a template for your final report.
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 15, 2016, 5:06 AM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 3, 2018, 11:25 PM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 3, 2018, 11:14 PM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 3, 2018, 11:32 PM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 15, 2016, 4:09 AM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Mar 23, 2016, 8:39 AM
Ċ
MUHAMMAD MUN`IM AHMAD ZABIDI,
Jun 9, 2016, 9:44 AM